Items:
0
Total:
$0
View Cart

Shopping Cart

0 item(s) in your shopping cart

ITEMS
QTY
PRICE
Total
 
[ITEM_NAME]
View/Hide options
This item will Autoship every [recurring_frequency]
[ITEM_PRICE]
[ITEM_SUBTOTAL]
Subtotal: $0
Your cart is empty.

10mm Glue-In Cuff Flat Leather Cord - Rose Gold

Brand:  BBNS BBNS
10mm Glue-In Cuff Flat Leather Cord - Rose Gold
10mm Glue-In Cuff Flat Leather Cord - Rose Gold

10mm Glue-In Cuff Flat Leather Cord - Rose Gold

Brand:  BBNS

Part Number:

10F-CF-1RG
Your Price:$13.25
review
0
0
5

Availability:

3 In Stock.
14.5x3.5mm
Outer Diameter: 6 3/4 inches - start with 7 inch piece of cord and trim
Adjustable - will fit most wrist sizes
Sold Individually
Brass Base Plated with rose gold
Blank Base to glue in 10mm flat cord
Designer Tip: Each bangle takes one bracelet blank and 6 inches of 10mm leather. The bracelet blanks have rounded corners and the ends are at a slight angle. Using sharp scissors or flush cutters, trim one end of the leather to fit the bangle. Glue the end in with Super New Glue and use tape or wire to hold the leather in place while drying. Spread a small amount of E-6000 on the bracelet blank starting from the glued portion to about inch away from the other end. Press leather in place and trim other end to fit in bangle. Apply Super New Glue to the end of bangle and press leather in place, again using tape of wire to hold the leather while the glue is drying. A nail file can be used to smooth the rounded corners if desired. If the Super New Glue does not hold, allow it to dry completely and reapply. The rationale for using the E-6000 everywhere but the ends is that is it bonds with some elasticity and will allow the bangle to be opened and closed without cracking. Super New Glue tends to be a bit more brittle when it is dry, and that is why we don't recommend it for the bendable part of the cuff, but will hold the ends strongly.

Related Items

Recently Viewed Items