Chocolate Drops Bulahan Wood and Cork Cord Riveted Bracelet
Want to make this Design Idea? See products and other information below.
7 inches Portuguese Cork Cord 10mm Flat - Mustard
1 Leather Clasp Magnetic Rectangle Rivet 10mm - Antique Brass
7 Tiger Ebony Wood Slide Large Hole Rondelle 5x12mm
12 Tiger Ebony Wood Bead Round 6mm
6 Tiger Ebony Wood Bead Rondelle 6x10mm
7 TierraCast Snap Rivets 6mm Bag of 10 - Antique Brass
6 TierraCast Rivet Eyelet 3.7mm - Antique Brass
6 Jump Ring 8mm 18g - Antique Brass
18 Head Pin 2 inch 20g - Antique Brass
Super New Glue®
Finished Length: 7 1/2 inches
Level of Difficulty: Beginner
Tools: Leather Cutter, Leather punch, rivet and eyelet setting tools
Designer Tip: Find center and mark with pen; mark 6 additional equidistant marks (about ½ inches apart) on both sides. Use leather punch to punch a small hole over each mark. Set eyelets in every other hole, starting in the second hole from the end. Use rivets to set the wood rondelles – hammer very gently so you don't crack the wood. Add a bead to each head pin and form a simple loop. Run jump rings through the eyelet holes and attach 3 beads to each jump ring. Check fit and trim leather if needed to ensure a good fit before gluing clasp on.