You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.
Designer Tip: Mark and, using the smallest (5/32 inch) setting on the leather punch, punch holes in the Arizona leather from the end of the Arizona leather as follows: ½ inch, 1 ¾ inch, 3 inches, 5 inches, 6 ¼ inches, and 7 ½ inches. Add the slide to the 5mm leather and center between the two middle holes. Lay the 5mm leather over the 20mm leather and curve the leather. Starting from the middle, rivet the 5mm leather to the 20mm leather (the rivets will just poke through braided leather; it is not necessary to punch holes). Be sure to continue to curve the 20mm leather when determining where to set the remaining rivets. Check the bracelet size and trim the 20 mm leather on both sides before gluing it into the clasp. NOTE: the braid will quickly start to unravel when the tape is removed so work one side at a time. Close the bracelet; trim the ends of the Arizona leather flush with the clasp and glue to the 20mm leather.