2 TierraCast Snap Rivets 4mm Bag of 10 - Silver Plate
Finished Length: 8 1/2 inches
Level of Difficulty: Beginner
Tools: Leather Punch, Hammer, 4mm Rivet Setter, 1/32" Nail Setter, Bench Block, Leather Cutter or Sharp Scissors
Designer Tip: SEE VIDEO LINKS BELOW. Fold the leather in half and add the slide to form a ¾ inch loop at the top. Check the size by inserting the leather through the two rings at the bottom of the clasp and folding it over about ½ inch; trim the leather if needed to ensure a good fit. Mark both ends of the leather 1/8” and 1” from the end; punch a hole using the smallest setting on the leather punch or a 1/32" nail setter. Insert the leather back through the rings of the clasp; place and set the rivets.